Vista: How to enable Contact ID
To enable reporting on a Honeywell VISTA-21iP, you must first ensure you have an alpha-numeric keypad (e.g., 6160) and the...
Honeywell
Vista: How to program house code
On a Honeywell Vista, the “House Code” is a two-digit identifier used to allow the panel to communicate with bi-directional...How to address 6160 keypad on Vista 21
To address a Honeywell 6160 keypad on a VISTA-21iP system, you must configure the address on the keypad itself and...Lynx: Summary of connections
PROTAKEOVER: Setup guide
The Takeover Module allows Resideo PRO Series control panels to communicate with previously installed wireless sensors and modules that transmit...PROA7: System operation
PROWLTOUCH Touchscreen Displays and OperationThe PROWLTOUCH touchscreen duplicates the functions of the Control Panel and mirrors its displays. Master User...IS-310: Install instructions
The IntelliSense® IS-310 is a Request-to-Exit Passive Infrared (PIR) sensor. Mounted near an exterior door inside a building with an...PROA7: Navigation Keys/Home Screen
System Status is displayed below the large icon on the left side of the touchscreen. In addition, the Home Screen...Lynx 5210: Summary of connections
VISTA-128/250: House ID Sniffer Mode
This mode applies only if you are using a wireless keypad (e.g., 5827) or bi-directional devices (e.g., 5804BD). Use the...Vista 250: Installing the 5800TM Module
Installation of this module is necessary only if you are using a 5804BD Bi-directional device. To install the 5800TM, perform...5816OD: Installation guide
General Information and Component Identification The Honeywell 5816OD Wireless Outdoor Sensor (referred to as the Sensor) brings the convenience of...DT8050A: Walk test
Walk test mode is active for 10 minutes, then automatically exits test mode, disables the LED and enters normal operation...DT8050A: Wiring Examples
To connect all three outputs (sensor alarm, tamper and trouble/anti-mask) to one zone input: All alarm, tamper and trouble/anti-mask events...Lynx 5xxx: How to add external siren
To install an external siren, you need to enable a few options in the programming and require a power supply...