Communication

To factory reset an Alula communication board or radio (such as the BAT-CDMA-WIFI or BAT-WIFI modules), you must tap the...

Updating firmware on an Alula cellular communicator or radio (such as the BAT-Connect) is handled automatically or remotely. It requires...

To upgrade the firmware on a NAPCO StarLink radio, log into the NAPCO NOC Radio Management Center, select your communicator,...

Connect the StarLink radio to the control panel output for Telco Trouble (this is the DACT interconnect wiring to the...

Configure all inputs and outputs using the Manage- ment Center screen (located at www.napconoc.com). Located at the bottom of the...

There are seven steps in installing Telguard properly. IF YOU DO NOT PROCEED IN THE ORDER AND MANNER PRESCRIBED, YOU...

The default program setting of the Telguard TG-1 Express is for Auto Detection of the panel alarm format. The Auto...

The Telguard TG-1 Express has an extremely low power profile, and as such can usually be powered from the panel...

To test the cell connection on your Qolsys IQ Panel, you can run a cellular test from the system’s test...

Enabling radio (cellular or wireless) communication on a DMP panel involves physical installation of a cellular communicator/receiver and programming via...

To program radio (cellular or IP) communication on a Vista 21iP system, you must enable the communicator in the panel’s...

General Information The LTE-X Series Communicator, herein referred to as the communicator, easily connects to your security system’s control panel...

Telco 1 is used for the Fire Panel to output contact ID messages to the HWF2-COM, and Telco 2 is...

LED Indicator  STATUS AC (green)  AC power available. ACTIVE (green)  Cyclical flashing – normal communications.Repetition of 3 flashes – loss...

The Telguard automatic self-test signal can be programmed to a daily, weekly or monthly schedule as prescribed by contract. The...