The system cannot be armed unless the ‘Ready’ light is on. If the ‘Ready’ light is not on make sure all protected doors and windows are secure and stop movement in areas covered by motion detectors. When the ‘Ready’ light is on enter any valid Access Code.
As each digit is pressed the keypad will beep. If an incorrect code is entered the keypad will emit a steady 2 second beep to indicate the code was not correct. If the code is correct but the ‘Ready’ light was not on the panel will beep six times rapidly followed by a long two second beep to indicate the system was not Ready.
When the correct code is entered and the system is Ready the panel will beep six times rapidly and the ‘Armed’ light will turn on. Exit the premises through the designated entry/exit door.
Note
The PC5010 has a built-in feature called Audible Exit Fault. Search for Exit Fault for more info.
To disarm the panel enter the premises through the designated entry/exit door. The keypad will emit a steady beep to warn that you must disarm the system.
During the last 10 seconds of entry delay the panel will pulse the keypad beeper on and off rapidly to warn the entry delay is about to expire. Enter a valid Access Code at the keypad. If an error is made, re-enter the code correctly.
When a correct code is entered the keypad will turn off the ‘Armed’ light and stop the keypad buzzer. If an alarm occurred while the panel was armed the ‘Memory’ light and the zones which caused the alarm will be flashing. Press the [#] key to return the keypad to the Ready state.