DSC

To program Contact ID format on a DSC Maxsys PC4020 control panel, enter the system programming mode using *8 plus...

Changing the entry delay on a DSC PowerSeries Neo requires access to Installer Programming. Note that industry standards (CP-01) typically...

PGP922 detects shattering glass. Like all glass-break sensors, the detector might not consistently detect cracks in glass, or bullets that...

The PGPx303 is a thin, ultra-long-life PowerG magnetic contact device that is compatible with Johnson Controls’ PowerG control panels. The...

Note: Remove all power from the system while connecting modules to the corbus. Note: All circuits are power limited. GND...

The HSM2164RF v1.0 features two LEDs to help with the installation of devices and troubleshoot the operation of the unit....

The PG9934(P)/PG8934(P)/PG4934(P) are 2-way wireless digital PIR/ Pet immune motion detectors with integrated cameras and microphones for alarm verification. The...

Each wireless device (excluding wireless keys) sends a supervisory signal periodically. If the receiver does not receive a signal in...

1. Enter Installer Programming section [803][000]. 2. When prompted, either activate the device to enroll immediately or enter a device...

Enrolling the HSM2164RF receiver Enter Installer’s Programming section [902] then [000] to auto-enroll the HSM2164RF. The HSM2164RF module is enrolled...