Enrolling the HSM2164RF receiver
Enter Installer’s Programming section [902] then [000] to auto-enroll the HSM2164RF. The HSM2164RF module is enrolled automatically if it is connected to the Neo panel corbus terminals. The module count increases on the screen (example. M:01).
The system detects a module supervisory trouble if it is removed from the corbus. If the HSM2164RF needs to be removed from the system by the installer, it must be unrolled from the system.
To delete the HSM2164RF from the alarm system complete the following.
- Enter [*][8][Installer Code].
- Enter installer’s programming section [902], then enter [111] Delete HSM2164RF. When prompted, press [*] to unenroll the module.
Note: Remove power from the alarm system before disconnecting any wiring from the module.
The system then generates an HSM2164RF Supervisory Trouble if the module is removed from the corbus. If you need to remove the HSM2164RF module from an existing system, unenroll it before powering down the system and disconnecting the wiring.
To view modules enrolled on the Neo system
- Enter [*][8][Installer’s code]
- Enter [903][000] to view all enrolled modules.