Program DSC PC5010 to use Contact ID
To program your DSC PC5010 (Power832) to use Contact ID, you need to set the monitoring phone number, account number,...
- Home
- pc5010
-
-
PC5010: Program wired zone
To program the onboard zone on a DSC PC5010, first enter programming mode by pressing *8 followed by the installer... -
PC5010 – Function Key Options
The following is a list of Function Key options available: [00] – Null KeyThe key is not used and will... -
PC5010 – Quick Arm / Quick Exit
Quick Arm If the Quick Arm Enable option is enabled the panel can be armed by entering [✱][0]. This is... -
PC5010 – User Functions (*+6)
This keypad command can be used to program several different functions. The following are the items programmable: [1] – Time... -
DSC (PC5010) – Door Chime On/Off
If enabled the keypad will beep 5 times rapidly when a zone is tripped and restored. The panel will only... -
DSC (PC5010) – Arming / Disarming
The system cannot be armed unless the ‘Ready’ light is on. If the ‘Ready’ light is not on make sure... -
DSC (PC5010) – Partition Master Codes
By default the Partition Master Codes are not programmed. They must be programmed by the System Master Code. A Partition... -
DSC (PC5010) – System Master Code
The System Master Code can be used to lock in the code. This will prevent the userfrom being able to...