Alarm Docs
  • Submit Article
  • Contact Us
  • About Us
  1. Home
  2. Qolsys
  3. Qolsys IQ4: Sensor status icons
Searching...

Other Articles

  • DMP XF6: Accessory devices
  • Reset Alula radio/communicator
  • How to add a zone to a VISTA H3
  • DMP XF6: Programming requirements
  • DMP XF6: Compatibility
  • DMP XF6: Wire the panel
  • DMP XF6: Install the panel
  • DMP XF6: Specifications Summary
  • XF6: Operating Instructions
  • Radionics: D168 Module Installation
  • PROA7PLUS: Re-register the radio
  • Install piezo on Honeywell Vista 21
  • S2000 – How to enter programming
  • DMP: Version 263 Update
  • Qolsys IQ4: Latest firmware version
  • Napco GEM-P1632: Error codes
  • Honeywell VISTA-128BPT compatible devices
  • Honeywell Vista 128BPT: ECP Error
  • Updating firmware on an Alula cellular communicator
  • How to update NAPCO StarLink firmware
  • How to adjust thermostat from IQ Panel 5
  • Create a guest code on the Qolsys IQ5
  • Programming VISTA-21iP for internet-only
  • Program user code on DMP XR/XT panel
  • Program the on-board triggers on Vista 21

Qolsys IQ4: Sensor status icons

The image below illustrates the definition of status icons on the IQ2 and IQ4 panels. This definition also applies to remote keypads connected to the IQPro panel.

Tagged: iconsstatus
Was this article helpful?
Yes No
© Copyright 2026 - AlarmDocs.Com