Alarm Docs
  • Submit Article
  • Contact Us
  • About Us
  1. Home
  2. Communication
  3. DSC Connect – Antenna Options
Searching...

Other Articles

  • DMP XF6: Accessory devices
  • Reset Alula radio/communicator
  • How to add a zone to a VISTA H3
  • DMP XF6: Programming requirements
  • DMP XF6: Compatibility
  • DMP XF6: Wire the panel
  • DMP XF6: Install the panel
  • DMP XF6: Specifications Summary
  • XF6: Operating Instructions
  • Radionics: D168 Module Installation
  • PROA7PLUS: Re-register the radio
  • Install piezo on Honeywell Vista 21
  • S2000 – How to enter programming
  • DMP: Version 263 Update
  • Qolsys IQ4: Latest firmware version
  • Napco GEM-P1632: Error codes
  • Honeywell VISTA-128BPT compatible devices
  • Honeywell Vista 128BPT: ECP Error
  • Updating firmware on an Alula cellular communicator
  • How to update NAPCO StarLink firmware
  • How to adjust thermostat from IQ Panel 5
  • Create a guest code on the Qolsys IQ5
  • Programming VISTA-21iP for internet-only
  • Program user code on DMP XR/XT panel
  • Program the on-board triggers on Vista 21

DSC Connect – Antenna Options

Date
October 11, 2024
Region
NA & LATAM
Product
DSC Connect / LE4050M

Supported Antennas

  • GSM-ANT1 (3 Feet)
  • GSM-ANT3 (10 Feet)

Dealer can also choose to utilize 3rd party antennas meeting the specifications below:

  • The impedance of the antenna and the cable must be 50 ohms.
  • The supported frequency must be between 700/850 or 1700/1900 MHz.
  • SMA Connector, SMT 13.5mm – 50 ohms
  • The maximum length should not exceed 20 feet

Tagged: antennadsc
Was this article helpful?
Yes No
© Copyright 2026 - AlarmDocs.Com