To add a Z-Wave device to your 2GIG control panel, you will first need to clear any existing network data from the device and then put the panel into “Add Device” mode to pair it. The specific steps may vary slightly depending on your 2GIG panel model (e.g., GC2, GC3, Edge).
Step-by-Step Pairing Guide (GC2 & GC3 Panels)
This process applies generally to the GoControl (GC2) and GC3 panels.
- Enter the Z-Wave Settings menu: From the home screen, tap Services, then the Z-Wave logo (or Smart Home Settings on newer models like the Edge).
- Access the Installer Toolbox: Tap the wrench icon (settings icon on the Edge) and enter your system’s Installer Code (the default code is typically 1561).
- Enter Exclusion Mode (Recommended first step):
- In the Z-Wave Toolbox/Smart Home Settings menu, select Remove Devices.
- The panel will begin listening to remove a device.
- Activate the exclusion function on your Z-Wave device (this usually involves pressing a button on the device, often the same button used for inclusion; refer to your device’s manual).
- The panel will beep and/or display a message when the device is successfully removed. Press Ok or Done.
- Enter Inclusion Mode:
- Return to the Z-Wave Toolbox/Smart Home Settings menu and select Add Devices.
- The panel will enter “learn” mode, listening for a new device.
- Activate the inclusion function on your Z-Wave device (again, this is typically the same button-press sequence as exclusion).
- When the panel discovers the device, it is automatically added.
- Enter DSK Code (For Z-Wave Plus S2 devices): If prompted, enter the first five digits of the device-specific key (DSK) code, found on a sticker on the device or its packaging.
- Confirmation: The panel will confirm the device has been added successfully. Tap Done to exit the menu and return to the home screen.
Pro Tips
- Proximity: For the best results during the pairing process, keep the Z-Wave device within a few feet of the 2GIG control panel.
- Manual Activation: The exact method to activate a device’s inclusion/exclusion function can vary by manufacturer (e.g., a single press, double-click, or a specific code for door locks). Always consult the specific Z-Wave device’s manual.
- Network Rediscovery: After adding all devices, it is a good idea to run a “Network Rediscovery” in the advanced Z-Wave menu to ensure all devices are communicating correctly and the network identifies the strongest pathways.