Mount the Enclosure
The XF6 Series panel enclosure must be mounted using the four mounting holes shown in the image below. Mount the enclosure in a secure, dry place to protect the panel from damage from tampering or the elements. It is not necessary to remove the panel PCB when installing the enclosure.
The enclosure dimensions are 13.44” H X 17.1” W X 4.8” D.
Note: For additional standby batteries, use the Model 350, 349, or 352S enclosures.
Remove the Door (Optional)
The XF6 Series panel enclosure includes a removable door for ease of mounting. Remove the harness from the PROG header on the panel. Push up on the hinges and slide the door off the enclosure.
Fire Command LCD Annunciator
A 7830F-R Fire Command Annunciator is factory installed on the panel enclosure door. The display and keyboard are factory pre‑wired to the PROG header. For standby battery calculations, the LCD display draws 84 mA of current in normal or standby conditions, and 108 mA in the alarm condition. For more information, refer to “Power Requirements”.
Additional 7830F-R annunciators can be added as needed.
Mounting Additional Annunciators, Zone Expanders, and Modules
All DMP annunciator housings are designed to install on any 4” square box, 3-gang switch box, compatible backboxes, or directly on a flat surface.
The DMP 711, 714, 715, and 716 modules are each contained in molded plastic housings with removable covers. The base provides you with mounting holes for installing the unit to a wall, switch plate, or other surface.
Mount any additional modules in the panel enclosure using the standard 3‑hole mounting pattern. Refer to the appropriate product guides for installation instructions.