Fire Alarm

Zones 1 to 6 (Terminals 17 to 28) on the panel are 24 VDC powered zones. For programming purposes, the...

To choose the type and number of batteries needed for 24 hours of standby power based on the Amp Hours...

The first time that the control panel is downloaded (whether initiated at the jobsite or remotely), a secret code is...

Drift compensation uses software algorithms that identify and compensate for long-term changes in the data readings from each address- able...

4.22: Walktest is a feature which allows one person to test the fire alarm system. An audible walktest will momentarily...

4.21.6: The control module delay feature, if enabled, will delay activation of a control module after a programmed time of...

LCD Display The FACP uses an 80-character (4 lines X 20 characters) high viewing angle LCD display. The display includes...

Class A or Class B wiring The following figure illustrates the maximum current that is possible for each major panel...

Programming a specific point on the Fire-Lite ES-50X panel typically involves using the built-in keypad/display for basic functions or utilizing...

Models SD365 and SD365-IV are plug-in type smoke sensors that combine a photoelectronic sensing chamber with addressable-analog communications. The sensors...

Notes on Protocols:

Green circle Indicates detector/panel compatibility with all firmware versions Yellow circle Indicates detector/panel compatibility with firmware version 02.00.011 or higher...

The FMM-1 Monitor Module is intended for use in intelligent, two-wire sys- tems, where the individual address of each module...

Gentex Notification Appliance Using the ELRD-2.2K The Gentex Commander III Notification Appliance requires the ELRD-2.2K to be installed across the...

Primary power required for the FACP is 120 or 240 VAC, 50/60 Hz, 3.25 amps. The FACP will auto-detect the...