Fire Alarm

Class A or Class B wiring The following figure illustrates the maximum current that is possible for each major panel...

Programming a specific point on the Fire-Lite ES-50X panel typically involves using the built-in keypad/display for basic functions or utilizing...

Models SD365 and SD365-IV are plug-in type smoke sensors that combine a photoelectronic sensing chamber with addressable-analog communications. The sensors...

Notes on Protocols:

Green circle Indicates detector/panel compatibility with all firmware versions Yellow circle Indicates detector/panel compatibility with firmware version 02.00.011 or higher...

The FMM-1 Monitor Module is intended for use in intelligent, two-wire sys- tems, where the individual address of each module...

Gentex Notification Appliance Using the ELRD-2.2K The Gentex Commander III Notification Appliance requires the ELRD-2.2K to be installed across the...

Primary power required for the FACP is 120 or 240 VAC, 50/60 Hz, 3.25 amps. The FACP will auto-detect the...

Products marked with a check mark have not received UL 864 9th Edition certification and may only be used in...

All wiring must be installed in compliance with the National Electrical Code, applicable local codes, and any special requirements of...

There are several common annunciator messages that the annunciator displays to inform the technician and end‑user. The common messages are...

Set Lockout Code Pressing CMD at the STOP option displays SET LOCKOUT CODE. This allows you to program a code...

The following steps can be used as a guide to wire the annunciator. Make certain all power has been removed...

The 850 Series Fire Alarm Pull Station is a die-cast metal manual pull station available in single action (850S) or...

Each DVC Series model is a multi-featured audio processor with digital audio functionality that operates as an event-driven audio message...