Adding the ADC-SWM150 to the Z-Wave network

For best results, we recommend bringing the Z-Wave controller into the area where the Smart Water Valve+Meter is installed.

1. Put the Z-Wave controller in Add mode.
2. Press the Network button on the side of the Smart Water Valve+Meter control unit to begin the Add process. The Network LED on the control unit will begin blinking.
3. After the Smart Water Valve+Meter is successfully added to the Z-Wave network, the Network LED on the control unit will turn solid. If the Network LED is not illuminated after the Add process, repeat steps 1 and 2.