The Alarm.com Smart Gateway (ADC-SG130) provides a dedicated Wi-Fi network for Alarm.com Wi-Fi video cameras. Featuring WPS, you no longer need to update cameras with complicated router passwords. Simply add to an Alarm.com account, plug into any wall outlet, connect to the existing router, and pair with a Wi-Fi camera for instant, secure Wi-Fi connectivity.
Add the Smart Gateway to an Alarm.com account
1. Use an Ethernet cable to connect the Smart Gateway to an open Ethernet (RJ-45) port on the existing router.
2. Connect the Smart Gateway’s DC power adapter and plug it in to a non-switched outlet.
NOTE: For optimal Wi-Fi performance, place the Smart Gateway on top of a table or in another location free from physical obstructions.
3. Add the device to the account by either selecting the account in MobileTech or by using a web browser and entering the following URL: www.alarm.com/addcamera. Type in the Smart Gateway’s MAC address to begin. The MAC address is included on the label on the back of the device.
Wi-Fi Protected Setup (WPS) mode
• WPS mode is the preferred way to add an Alarm.com Wi-Fi camera to the Smart Gateway’s Wi-Fi network.
• Be sure to add the Smart Gateway to an Alarm.com account before using WPS mode to add video cameras to the Wi-Fi network.
• To enter WPS mode, use either the Trigger WPS feature in MobileTech or press and hold the WPS button for approximately 1 to 3 seconds. The Wi-Fi LED will slowly flash to indicate that the device is in WPS mode.
Reset
Press and hold the Reset button (pinhole) for 15 to 20 seconds (use a paper clip or tool if necessary). All LEDs will flash simultaneously to indicate that the device will reset. Wait for the Power and Communication LEDs to become solid before trying to use the device again.