Bypasses are performed to eliminate burglary zones that are not ready or faulty from activating the security system.
BYPASS PROCEDURE
Depress the BYPASS key followed by your user code and the two digit zone number to be bypassed (BYPASS [USER] ZN).
BYPASS [USER] 02
Multiple zones may be bypassed by repeating the sequence for the desired number of zones within a fifteen second interval, as follows:
EXAMPLE: BYPASS [USER] 02 BYPASS 04 BYPASS 12 The sequence displayed above would have bypassed zones 2, 4 and 12.
Zones can be bypassed if the user performing the bypass is authorized to perform bypasses and the zone has been defined by your installer as bypassable.
If the zone has already been bypassed, the sequence will unbypass the zone except if the system is armed and the unbypassed zone is still not ready. Unbypass means that the zone returns as an active burglary zone.
After the bypass (or unbypass) command has been accepted the unit will emit a continuous beep and zone or zones that have been bypassed will appear in a slow blinking mode in the zone status area.
Note: Bypassing can be performed either while the system is armed or disarmed.