Alarm Docs
  • Submit Article
  • Contact Us
  • About Us
  1. Home
  2. legend
Searching...
  • Legend 100: System operation

    AC INDICATOR This light indicates that AC power is connected to the Security System. Battery backup exists to operate the...
  • Legend 100: Keypad emergency conditions

    In addition to individual zone alarms various conditions can be transmitted directly through the keypad. These conditions are initiated through...
  • Legend 100 – Zone Baypass

    Bypasses are performed to eliminate burglary zones that are not ready or faulty from activating the security system. BYPASS PROCEDURE...
  • Legend 100 – Relay #1

    Relay 1 can be used a bell output or as dry contact as shown bellow:

Other Articles

  • XR 500 – Zone Expansion
  • What is IQ5 Hub
  • Programming VISTA-21iP for internet-only
  • VUE Video Doorbell
  • Alarm.com doorbell network requirements
  • XF6: Common Annunciator Messages
  • Lynx: How to add Z-Wave device
  • DMP: Service Request
  • Neo: Wireless supervision time
  • TG-7: Link Supervision
  • MS-9200: Notification Appliance Circuits
  • XR 500 – Keypad Bus
  • DSC (PC5010) – Partition Master Codes
  • NX-148E: Changing user code
  • DMP: User Profiles (Info)
  • Legend 100 – Relay #1
  • Vista: Keypad error codes
  • NFS-640: DVC Digital Voice Command
  • Qolsys IQ: Sensor test
  • VISTA-128BPT/250BPT: System Commands
  • Install ADC-VDB750
  • Install 714N-POE Network Zone Expander
  • 4190SN: Installation & Setup
  • DMP – 716 Output Expansion Module
  • QolSys (IQ4) – Connect to Wi-Fi
© Copyright 2026 - AlarmDocs.Com