Unlike zones and keypads, each of the 128 users can be assigned to multiple partitions (programming question#026). Also, users can be enabled to send Opening/Closing signals to the CS by partition (programming question#027). Once enabled, the user’s functions (arming, disarming, bypass, etc.) in the partition depends on its AUTHORIZATION LEVEL…
This section provides a list of all available programming options in numerical order. To program, access Installer Programming mode by keying in [*][8] [Installer Code]. se the scroll keys < > to navigate through the menus or jump directly to a specific section by keying in a section number and…
The XR150/XR550 Series diagram below shows some of the accessory modules you can connect for use in various applications. A brief description of each module follows.
You can connect devices to the LX-Bus/AX-Bus and Keypad Bus through the PROG, LX500, LX600, LX700, LX800, and LX900 4-pin headers and the keypad bus. Several factors determine the DMP LX-Bus/AX-Bus and keypad bus performance characteristics including the wire length and gauge use, the number of devices connected, and the…
The XR550 panel can communicate using AES encryption. If you currently have an XR550 panel with network capability, you may contact DMP Customer Service with the panel serial number. The serial number(s) should be sent in writing via e-mail. separate feature key is sent for each panel to activate encrypted…
You can connect the following devices to the LX-Bus™ connections provided on the panel:
The Bypass function excludes a zone of protection from the security system until it is unbypassed (either by using the unbypass procedure or when you turn the system OFF). Bypassing can only be done while the system is turned OFF. Press the BYPASS button. Then enter your user code and…
Bypasses are performed to eliminate burglary zones that are not ready or faulty from activating the security system. BYPASS PROCEDURE Depress the BYPASS key followed by your user code and the two digit zone number to be bypassed (BYPASS [USER] ZN). BYPASS [USER] 02 Multiple zones may be bypassed by…
Relay 1 can be used a bell output or as dry contact as shown bellow:
The GEM-RP1CA/RP1CAe/RP1CAe2 Keypad can display the following messages. The GEM-RP2AS/RP2ASe/RP2ASe2 will display similar abbreviated messages that may scroll through two screens. SYSTEM READY CW1 – All zones operating; system can be armed. GEM-RP1CA/RP1CAe RP1CAe2 only: C = Chime Mode on; W = Watch Mode on; 1-8 = Area.PLEASE WAIT –…