The Bypass function excludes a zone of protection from the security system until it is unbypassed (either by using the unbypass procedure or when you turn the system OFF). Bypassing can only be done while the system is turned OFF.
Press the BYPASS button. Then enter your user code and the zone number (1-7) to be bypassed, as follows:
BYPASS followed by your user CODE + ZONE NUMBER
Example: BYPASS 1234 02 (This command will bypass zone 2).
If the Quick Bypass feature has been enabled by the installer, the user code is not required when bypassing zones.
NOTE: Bypassed zones are NOT protected when the system is turned ON. After the bypass command has been accepted, the keypad will sound one long beep, and the zone LED of the zone(s) bypassed will slowly blink, or the LCD will display: BYPASS ZONE 02 FRONT DOOR ..
IMPORTANT: Temporary users (i.e., baby sitters, housekeepers, etc.) should not be shown the Bypass procedure.
TO UNBYPASS A ZONE
Pressing the BYPASS button returns a bypassed zone to normal operation. To unbypass a zone(s), repeat the bypass function as follows:
BYPASS followed by your user CODE + ZONE NUMBER
After unbypassing, the zone display will show the state of the zones.