The 5869 Holdup Switch/Transmitter is a finger-operated RF transmitting device used for activating a holdup signal at the security system control, and/or any other security application. The 5869 is typically mounted under a counter or money draw for inconspicuous operation. When the transmitter is activated, it sends an RF signal…
To program a PG9933 on a Qolsys panel, you must first put the panel in “Auto-Learn Sensor” mode, then install the battery in the PG9933 to trigger the enrollment signal. After the panel detects the sensor, confirm the serial number and configure the zone settings, setting the sensor type to…
The ADEMCO 4190SN V-Plex is a 2- zone expander, which allows use of the available expansion zones provided by controls that support V-Plex loop devices. The 4190SN consists of two protection loops, known as the left (primary) and right (secondary) loops. The left loop can be used for: Follow the…
To program a PG9920 repeater on a Qolsys panel, first put the panel into “Auto-Learn Sensor” mode by going to Settings > Advanced Settings > Installer Code > Installation > Devices > Security Sensors > Auto-Learn Sensor. Then, follow the PG9920’s installation manual to activate the device; this usually involves…
To program a DSC PG9938 panic switch on a Qolsys panel, enter Installer Code in Settings > Advanced Settings > Installation > Devices > Security Sensors > Auto Learn Sensor to start the enrollment mode. Then, press and hold the PG9938’s button until the LED light flashes and turns solid,…
The NBG-12LX Addressable pull station is a non-coded, dual-action manual pull station with a key-lock reset feature. It provides NOTIFIER intelligent fire alarm control panels (FACP) with one addressable alarm initiating input. The addressable module is housed in- side the pull station. The NBG-12LX is compatible with all Notifier intelligent…
Before You Begin Read this guide before you begin programming. This guide allows you to quickly learn the programming options and operational capabilities of the CellCom Series communicator. The communicator contains all of its programming information in an on-board processor and does not require an external programmer. Programming Sheet Fill…
AP mode To ensure the device will have a sufficient Wi-Fi signal. WPS mode
Note: This method will also enroll the device to the customer’s account as part of the process. To connect devices via BLE mode using the Customer app:
PROGRAM IN DEALER ADMIN After you’ve installed the X1 Series Door Controller and configured basic communication settings, follow the steps in each of the following sections to program the door controller in Dealer Admin: Sign In to Dealer Admin Go to the Dealer Admin login page. Enter your Email and Password, then…