ADC-V730: Enroll using AP & WPS

AP mode

To ensure the device will have a sufficient Wi-Fi signal.

1. Connect the camera’s AC power adapter and plug it into a non-switched outlet.
2. The camera’s LED will begin to blink white. If the LED is not white after two minutes, press and hold the WPS/ Reset button and release when the LED begins to blink white (about 3 seconds).
3. On an Internet-enabled device, connect to the Wi-Fi networkADC-V730 (XX:XX:XX) whereXX:XX:XX is the last six characters of the ADC-V730’s MAC address, which is located on the camera or on the packaging.
4. On the same device, open a web browser and enter http://v730install or 192.168.1.1 in the URL field. Follow the on-screen instructions to add the ADC-V730 to the Wi-Fi network. The LED will briefly turn red before blinking green. The LED will be solid green when the connection is complete.

WPS mode

1. Connect the camera’s AC power adapter and plug it into a non-switched outlet.
2. After the startup process is complete (the camera’s LED will be blinking white), press and hold the WPS/Reset button and release when the LED begins to blink blue (about 6 seconds).
3. Activate WPS mode on the router. The camera will begin to connect to the Wi-Fi network. The LED will be solid green when the connection is complete.