Alarm Docs
  • Submit Article
  • Contact Us
  • About Us
  1. Home
  2. Honeywell
  3. Vista 128: Chime mode
Searching...

Vista 128: Chime mode

Your system can be set to alert you to the opening of a door or window while it is disarmed by using CHIME mode. When activated, three tones will sound at the Keypad whenever a protected perimeter door or window is opened, and the Not Ready message will be displayed. Pressing the READY key will display the open protection points.

Using the 9 Key

Note: that Chime mode can be activated only when the system is disarmed.

Tagged: chime
Was this article helpful?
Yes No

Other Articles

  • Qolsys IQ Panel 5: How to change the battery
  • What is IQ5 Hub
  • Fire-Lite MS-5210UD: System Supervisory Restoral Response
  • Fire-Lite MS-5210UD: System Supervisory Condition Response
  • Understand Brivo ACS100 product compatibility
  • Understand the function of the Brivo ACS100-E control panel
  • Verify connection of the LAN to the Brivo ACS100
  • Resetting the Brivo ACS100 to factory default
  • MS-5210UD: Optional modules
  • Ademco 5817CBXT: Installation Instructions
  • Honeywell 5817CBXT: Product summary
  • What is Vista 128 Polling Loop (V-PLEX)
  • DMP XF6: Accessory devices
  • Reset Alula radio/communicator
  • How to add a zone to a VISTA H3
  • DMP XF6: Programming requirements
  • DMP XF6: Compatibility
  • DMP XF6: Wire the panel
  • DMP XF6: Install the panel
  • DMP XF6: Specifications Summary
  • XF6: Operating Instructions
  • Radionics: D168 Module Installation
  • PROA7PLUS: Re-register the radio
  • Install piezo on Honeywell Vista 21
  • S2000 – How to enter programming
© Copyright 2026 - AlarmDocs.Com