The receiver can support up to 16 encrypted wireless transmitters (keys) at one time. If the number on the receiver microprocessor is WAK 4406-4 or higher, the receiver provides you with the capability to check space available and/or delete encrypted keys using the procedures below.
The GREEN LED located on the receiver’s circuit board may be used to determine how many more encrypted keys may be enrolled into the receiver. This LED is also used to indicate when encrypted keys may be deleted. To determine how many more encrypted keys may be enrolled and/or to delete enrolled encrypted keys:
1. Remove power from the receiver and set DIP switch 1 to the ON position.
2. Apply power to the receiver and watch the GREEN LED. You will see one of the following indications:
- The GREEN LED blinks the number of spaces that are free for additional encrypted key enrollment and then goes to constantly ON.
- The GREEN LED is constantly ON, indicating the receiver is full.
- The GREEN LED is OFF, indicating no encrypted keys are enrolled.
4. If you do not want to delete any enrolled encrypted keys, advance to step 4. If you want to delete enrolled encrypted keys, wait until the GREEN LED is constantly ON in step 2 a. or 2 b. above and then:
- Record the positions of DIP switches 1 through 5.
- Set DIP switches 1 through 5 to the opposite positions of their current settings and wait a few moments.
- Set DIP switches 1 through 5 back to their original positions as recorded in step a. All enrolled encrypted keys will be deleted.
4. Place DIP switch 1 back into the OFF position to return to normal receiver operation.