• IQ INSTALLER

    • May 29, 2026
    • The Master

    IQ Installer allows for local system installer programming over Wi-Fi via an iOS or Android device, in place of the built-in touchscreen found on IQ Panel 4 & 5. This application can be downloaded on both the App.

  • DMP: 860 relay module

    • May 27, 2026
    • The Master

    Dry relay contacts on the 860 Module are programmable and controlled from panel annunciator outputs. The module includes one Form C (SPDT) relay rated for 1 Amp at 30 VDC. The 860 Module also provides three additional sockets for Model 305 Plug-In Output Relays (12 VDC). Relays can be used…

  • 711: Zone Expansion Module

    • The Master

    Zone expansion modules allow you to increase the number of reporting zones available on DMP panels. Refer to the panel installation guide for more information about zone expansion modules and the maximum number allowed per panel. The modules connect to the panel 4-wire Keypad Bus or LX-Bus and are set…

  • GEMC-EZM8 – Installation Instructions

    • May 2, 2026
    • The Master

    The capacity of the GEMC-Series control panels may be expanded through the use of a GEMC-EZM8 Zone Expan- sion Module. Each GEMC-EZM8 module provides up to 8 additional zones, and may be configured to provide for ei- ther 4 zones or 8 zones. Using either configuration, several GEMC-EZM8 modules may…

  • PG-WLSHW: Wiring a fire zone

    • April 18, 2026
    • The Master

    If you program PGM2 for use with a 2-wire smoke detector, you must wire it according to thefollowing figure: Wiring a CO detector or 4-wire smoke detector The following table lists the maximum rating at 12 VDC of the hardwired CO detectors that are compatible with the PG9WLSHW8 converter. To…

  • EVD-2 wiring with 2 additional EVD-R

    • April 16, 2026
    • The Master

    Recommended Wiring EVD-2 System (Shown with 2 additional EVD-R remote pickups). Recommended Wiring Figure 4 shows the recommended wiring for an EVD-2 system with two additional EVD-R remote pickups. (All wiring should be as specified in Table 1 or with UL listed equivalents.) 1. Cable clamp knockout locations are shaded. Be sure…

  • Vista: How to enable Contact ID

    • February 21, 2026
    • The Master

    To enable reporting on a Honeywell VISTA-21iP, you must first ensure you have an alpha-numeric keypad (e.g., 6160) and the installer code (default is 4112). Enter programming mode by entering [Installer Code] + 8 + 0 + 0. Set the communication format by entering *48, then input 7 for both…

  • ADC: Internet connection type compatibility

    • February 1, 2026
    • The Master

    Alarm.com video devices need an indefinite, always-on internet connection to function reliably. Some internet connections are incompatible due to restrictions they impose on bandwidth usage. Bandwidth requirements Alarm.com video devices only use bandwidth when the user is streaming live video or SVR recorded footage, or when the device is uploading recorded video clips.  Alarm.com video devices…

  • StarLink SLE-LTE: Wiring diagram

    • January 25, 2026
    • The Master

    Connect the StarLink radio to the control panel output for Telco Trouble (this is the DACT interconnect wiring to the radio). Remember to program the StarLink communicator module to report this IN2 Telco Trouble and for line cut (EOLR) to the central station (options 1 or 4 on page 17). In addition,…

Next