To program a PG9920 repeater on a Qolsys panel, first put the panel into “Auto-Learn Sensor” mode by going to Settings > Advanced Settings > Installer Code > Installation > Devices > Security Sensors > Auto-Learn Sensor.
Then, follow the PG9920’s installation manual to activate the device; this usually involves inserting batteries, and the panel should automatically recognize and enroll it. Finally, follow the on-screen prompts to configure the zone settings and test the device.
Enter auto-learn mode on the Qolsys panel
- From the main screen, tap the small grey bar at the top of the screen.
- Navigate to Settings > Advanced Settings.
- Enter the installer code (the default is 1111).
- Tap Installation > Devices > Security Sensors > Auto-Learn Sensor.
Activate the PG9920 repeater
- Follow the specific instructions in the PG9920 Installation Manual.
- For a new device, this typically involves inserting the batteries.
- The panel should automatically detect the signal from the repeater and prompt you to enroll it.
Configure and test the device
- Follow the on-screen prompts to configure the zone settings, which may include setting the sensor type, sensor group, and a sensor name.
- Tap the save button.
- Test the device to ensure it is functioning correctly, as outlined in the PG9920 Installation Manual.