• Create new system user codes

    • September 28, 2025
    • The Master

    Generate user codes using the Alarm.com app: Generate user codes using the Alarm.com customer website:

  • ADC-T25 – Installation Guide

    • The Master

    Installation Precautions In the box Thermostat Overview Preparation Thermostat Installation Setup Depending on the system type and configuration, the thermostat may request the following information during setup: Heat Type: Tells the thermostat whether it should turn on the fan during a heating cycle. Test the System After successfully installing and…

  • Install ADC-VDB750

    • The Master

    Physical installation If there is no wired in-home chime, verify that the power source (AC or DC) meets the product requirements, and wire directly (polarity does not matter) to the ADC-VDB750 (no in-line resistor is required). Remove the existing doorbell from the wall and disconnect the wires. Secure the wires…

  • 5828 – Installation and setup

    • The Master

    GENERAL INFORMATION The ADEMCO 5828 and 5828V are wireless, bidirectional, fixed-word, keypads that may be used in conjunction with LYNX and VISTA series residential control panels. VISTAsystems require use of either a 5883 Transceiver (micro P/N WAK5119-X, where X = 3 or higher), 6150RF Keypad/ Transceiver (PC board P/N SA6150RFAS-T3…

  • 4219 – Installation Instructions

    • The Master

    GENERAL INFORMATION This module adds up to 8 end-of-line resistor supervised zones to compatible control/communicators via the control’s keypad wiring. The module may be mounted within the control’s cabinet (if room permits), or remotely. If mounted remotely, there are provisions to tamper protect the unit. Communication to the module is…

  • DSC Connect – Antenna Options

    • September 27, 2025
    • The Master

    Supported Antennas Dealer can also choose to utilize 3rd party antennas meeting the specifications below:

  • PGx979 Wireless Heat Detector Installation Guide

    • The Master

    PGPx979 is a wireless heat detector with a fixed temperature, a rate of rise heat sensor, and an internal piezoelectric alarm. The device detects a rise in temperature due to fire. The heat detector is suitable for use in locations where a certain level of smoke is normal, for example…

  • IQ4 – FlexTilt camera adjustment

    • The Master

    FlexTilt camera adjustment allows the built-in Panel Camera to be angled up or down depending on the installation need. This is especially helpful when wall mounting over an existing keypad location that may be higher or lower than usual, or when table stand mounting.

  • QolSys (IQ4) – Install the panel

    • The Master

    Note: For UL/ULC Commercial Burg installations (UL2610/ULC-S304 Security Level II compliant) use only wall mount option. IMPORTANT IF USING CUSTOM LENGTH WIRE 7vDC Transformer: Use 18AWG wire no longer than 98.5ft to ensure sufficient power is received at the panel.

  • DMP – 1100R Series Wireless Repeater

    • The Master

    The 1100R Series Wireless Repeater increases the wireless communication range and improves the signal quality between the DMP wireless receiver and transmitters. The 1100R features 128-bit AES encryption and supports DMP encrypted wireless devices. Up to eight repeaters can be installed on a wireless system. The repeater is powered from…

Prev Next