To regain access to “backdoor” programming on a Honeywell LYNX Touch L5210 panel, you must execute a specific power-cycle sequence and button press combination to bypass a lost installer code. This method becomes necessary when the installer code has been altered, and the option to permit re-entry into programming has…
Enroll/Reset button will enable Device Link enroll mode if held for 2 seconds (Device Link LED will flash), reset the BAT-Connect if held for 5 seconds, and if held for approximately 10 seconds will factory default the BAT-Connect.
Generic Alarm Panel Programming Any control panel can be supported for event reporting as long as it provides Tip & Ring connection and transmits events in Contact ID format. Tip & Ring should not be wired to BAT-Connect using the same multi-conductor cable as the panel wiring. Tip & Ring…
BAT-Connect is a device that connects to security panels and provides interactive services, home automation, and the ability to update the user interface. Installation Overview Connecting via ethernet: Plug in cable and ensure ethernet LED is on. Connecting via cellular: Verify cellular LED is on and verify signal strength. Connecting…
Figure 4-13 illustrates, in more detail, the programming flow when in the SK-5280 outputs menu. If Zones 1-10 is selected then the SK-5280 will output when alarms and troubles occur for zones 1 through 10. If Zones 11-20 is selected then SK-5280 will output when alarms and troubles occur for…
Figure 4-11 illustrates, in more detail, the programming flow when in the line options menu.
Table 3-3 shows the maximum battery standby load for the SK-5208 based on 24 and 60 hours of standby. The standby load calculations of line D in the Current Draw Calculation Worksheet (Table 3-2) must be less than the number shown in Table 3-3 for the battery size used and…
Power-limited and nonpower-limited circuit wiring must remain separated in the cabinet. All power-limited circuit wiring must remain at least 0.25″ (6.35 mm) away from any nonpower-limited circuit wiring. Furthermore, all power-limited circuit wiring and nonpower-limited circuit wiring must enter and exit the cabinet through different knockouts and/or conduits. A typical…