EVD-2 wiring with 2 additional EVD-R
Recommended Wiring EVD-2 System (Shown with 2 additional EVD-R remote pickups). Recommended Wiring Figure 4 shows the recommended wiring for an...
- Home
- Accessories
Accessories
OPTEX Beams: Master/slave selector switch setting
The master/slave selector switch is provided for preventing cross talk between infrared beams for multi-level alarm. From the top level,...OPTEX Beams: Wiring
OPTEX Beams: Terminal connections
Do not exceed the voltage or current rating specified for any of the terminals during installation, doing so may cause...HUSK-20: Installation guide
The HUSK-20 is a mechanical hold-up switch designed for silent operation. It is activated by using one finger to press...324P: Installation Sheet
The Model 323 and 324P are wire-in transformers on a mounting plate to be installed in any 350 or 350A...ELK-924: High current switching
Wire jumpers are used to tie Relays “A” and “B” in parallel for high current switching. Currents as high as...ELK-924: Dual switch
The relays are used to switch two different The ELK-924 is powered by the control panel and triggered by a...AX-350DH: Terminal connections
Do not exceed the voltage or current rating specified for any of the terminals during installation, doing so may cause...SMP5: Power Supply/Charger
SMP5 power supply/charger converts low voltage AC input into 6VDC, 12VDC or 24VDC @ 4 amp of continuous supply current...SMP3 – Power Supply/Charger
SMP3 power supply/charger converts low voltage AC input into 6VDC, 12VDC or 24VDC @ 2.5 amp of continuous supply current...