CellCom: How to activate
ACTIVATE THE CELLULAR MODULE Dealer Admin Activation Remote Link Activation
CellCom – Instalation & Setup
- The Master
The CellCom Series Universal Alarm Communicator provides a fully supervised alarm communication path for any burglary, commercial fire, or residential fire control panel. The CellCom Series can be connected to any control panel’s dialer output and used to capture Contact ID messages based on SIA DC-05-1999.09-DCS. The communicator also provides…
5800SMOKEV: Installation and Setup
- October 20, 2025
- The Master
This is a multi-criteria wireless smoke detector which employs advanced levels of detection and discrimination. This reduces common cooking nuisance alarms and allows faster detection to different types of fire conditions. It is intended for use with Control Panels that support 5800 series devices. To remove the mounting bracket, turn…
5800MINI: Installation Instructions
- October 19, 2025
- The Master
5800 Mini – One Zone Door/Window Transmitter Installation Instructions MOUNTING 1. Mount the 5800MINI & Magnet 2. Pull the Battery Tab PROGRAMMING
CM-30E: Installation Instructions
- The Master
Camden CM-30 series illuminated Exit switches are designed to mount into a deep style single gang electrical box. The large 2” square translucent button is easy to push. One momentary micro switch is provided with Form C output, rated at 10 amps @ 125 VAC. Standard models are supplied with…
Speco NRE: License Plate Detection/Recognition View
- The Master
Only when the ANPR camera is added and enabled, can license plates be captured and matched. The setting steps are as follows: Then you can see the captured plates displayed in the live view interface as shown below. Put the cursor on the captured plate picture and then click the…
Speco NRE: Event Search
- The Master
Click Start > Search and Export > Event Search to go to “Event Search” tab as shown below. Check the event type in the interface as required.
Speco NRE: View Disk and S.M.A.R.T. Information
- The Master
Click Start > Settings . Disk > View Disk Information to view the HDD information; click “S.M.A.R.T. Information” to view the working status of the HDD. Refer to the picture below.
Speco NRE: Advanced Configuration
- The Master
Click Start > Settings > Record > Advanced to go to the following interface. Enable or disable cycle record (cycle record: the earliest record data will be replaced by the latest when the disks are full). Choose the record stream. Set the pre-alarm record time, post-alarm record time and expiration…
Speco NRE: Record settings
- The Master
Format the HDDs before recording. Click Start > Settings > Record > Mode Settings to go to the mode settings interface. You can set the record time under the “Manual Record Settings” and then click “Apply” to save the settings. There are two record modes: auto mode and manual mode….